47-17
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 47 Configuring Cisco Intercompany Media Engine Proxy
Configuring Cisco Intercompany Media Engine Proxy
What to Do Next
Create the media termination instance on the adaptive security appliance for the Cisco Intercompany
Media Engine Proxy. See Creating the Media Termination Instance, page 47-17.
Creating the Media Termination Instance
Guidelines
The media termination address you configure must meet these requirements:
• If you decide to configure a media-termination address on interfaces (rather than using a global
interface), you must configure a media-termination address on at least two interfaces (the inside and
an outside interface) before applying the service policy for the Cisco Intercompany Media Engine
Proxy. Otherwise, you will receive an error message when enabling the proxy with SIP inspection.
Note Cisco recommends that you configure the media-termination address for the Cisco Intercompany
Media Engine Proxy on interfaces rather than configuring a global media-termination address.
• The Cisco Intercompany Media Engine Proxy can use only one type of media termination instance
at a time; for example, you can configure a global media-termination address for all interfaces or
configure a media-termination address for different interfaces. However, you cannot use a global
media-termination address and media-termination addresses configured for each interface at the
same time.
Note If you change any Cisco Intercompany Media Engine Proxy settings after you create the
media-termination address for the proxy, you must reconfigure the media-termination address by
using the no media-termination
command, and then reconfiguring it as described in this
procedure.
Procedure
Create the media termination instance to use with the Cisco Intercompany Media Engine Proxy.
The example command lines in this task are based on a basic (in-line) deployment. See Figure 47-6 on
page 47-11 for an illustration explaining the example command lines in this task.
To create the media termination instance for the Cisco Intercompany Media Engine Proxy, perform the
following steps:
Step 5
hostname(config)# access-list id permit tcp any host
ip_address eq 6084
Example:
hostname(config)# access-list ime-traffic permit tcp
any host 192.168.10.12 eq 6084
Adds an ACE. This ACE allows the adaptive
security appliance to allow traffic from the Cisco
Intercompany Media Engine server to remote Cisco
Intercompany Media Engine servers.
Step 6
hostname(config)# access-list id permit tcp any host
ip_address eq 8470
Example:
hostname(config)# access-list ime-bootserver-traffic
permit tcp any host 192.168.10.12 eq 8470
Adds an ACE. This ACE allows the adaptive
security appliance to allow traffic from the Cisco
Intercompany Media Engine server to the Bootstrap
server for the Cisco Intercompany Media Engine.
Command Purpose
To Next Page
Loading...
Need help?
General
