7-29
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 7 Using the Startup Wizard
Feature History for the Startup Wizard
• To obtain an IP address from a PPPoE server, click the Use PPPoE radio button.
• To obtain an IP address from a DHCP server, click the Use DHCP radio button.
–
To obtain an IP address for the default gateway using DHCP, check the Obtain default route
using DHCP check box.
Step 3 On the IPv6 Interface Settings tab, do the following:
• To enable the IPv6 interface, check the Enable IPv6 for the Interface check box.
• To add an IPv6 interface address, check the Add an IPv6 Address check box.
• Specify the IPv6 address and prefix length (for example, fe80:aabb::). Multiple addresses with
prefixes are allowed; however, no two addresses can be repeated within the list of addresses.
–
To configure an address using the EUI 64-bit interface identifier format, check the EUI 64 check
box.
Step 4 Click Next to continue.
Feature History for the Startup Wizard
Table 7-3 lists each feature change and the platform release in which it was implemented. ASDM is
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 7-3 Feature History for the Startup Wizard
Feature Name Platform Releases Feature Information
Startup Wizard 7.0(1) This feature was introduced.
To Next Page
Loading...
Need help?
General
