7-13
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 7 Using the Startup Wizard
Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
Note IPSec with PAT may not work correctly, because the outside tunnel endpoint device cannot
handle multiple tunnels from one IP address.
• To use the IP address of the outside interface for PAT, click the Use the IP address on the outside
interface radio button.
• To indicate a particular address to use for PAT, click the Specify an IP address radio button.
–
Enter an IP address for the outside interface for PAT.
–
(Optional) Choose a subnet mask from the drop-down list.
• To allow traffic through the adaptive security appliance without translation, check the Enable
traffic through the firewall without translation check box.
Step 3 Click Next to continue.
Step 16 - Administrative Access
To configure management access on the adaptive security appliance, perform the following steps:
Step 1 To add or change the access type, an interface, and then specify the IP address and netmask of the host
network that may connect to that interface for management purposes only, see the “Adding or Editing
Administrative Access Entry” section on page 7-13.
• The Type column specifies whether the host or network is accessing the adaptive security appliance
through HTTP over SSL in ASDM, SSH, or Telnet.
• The Interface column displays the host or network name.
• The IP Address column displays the IP address of the host or network.
• The Mask column displays the subnet mask of the host or network.
Step 2 To enable a secure connection to an HTTP server to access ASDM, check the Enable HTTP server for
HTTPS/ASDM access check box.
Step 3 To allow ASDM to collect and display statistics, check the Enable ASDM history metrics check box.
Step 4 Click Next to continue.
Adding or Editing Administrative Access Entry
Step 1 To configure the hosts, in the main ASDM application window, choose one of the following:
• Configuration > Properties > Device Access > HTTPS/ASDM
• Configuration > Properties > Device Access > Telnet
• Configuration > Properties > Device Access > SSH
• Configuration > Properties > History Metrics
Step 2 Choose one of the following preconfigured connections for the CLI console sessions from the Access
Type drop-down list:
To Next Page
Loading...
Need help?
General
