7-3
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 7 Using the Startup Wizard
Startup Wizard Screens for ASA 5500 Series Adaptive Security Appliances
Startup Wizard Screens for ASA 5500 Series Adaptive Security
Appliances
Table 7-1 lists all of the required Startup Wizard screens for configuring the ASA 5500 series adaptive
security appliances and IPS, if you have an AIP SSM installed. The actual sequence of screens is
determined by your specified configuration selections. The Availability columns lists the mode or modes
in which each screen appears and provides additional configuration information. Click the name to view
information for the selected screen.
Startup Wizard Screens for the ASA 5505 Adaptive Security
Appliance
Table 7-2 lists all of the required Startup Wizard screens for configuring only the ASA 5505 adaptive
security appliance and IPS, if you have an AIP SSC installed. The sequence of screens listed represents
configuration for the single, routed mode. The Availability columns lists the mode or modes in which
each screen appears and provides additional configuration information. Click the name to view
information for the selected screen.
Table 7-1 Startup Wizard Screens for ASA 5500 Series Adaptive Security Appliances
Screen Name Availability
Step 1 - Starting Point or Welcome, page 7-4 All modes.
Step 2 - Basic Configuration, page 7-5
Step 3 - Time Zone and Clock Configuration,
page 7-5
Not available in multiple mode.
Step 4 - Auto Update Server, page 7-6 Single, routed, and transparent modes. If enabled
in single transparent mode, the Interface
Configuration and Step 14 - DHCP Server screens
are not available.
Step 5 - Management IP Address Configuration,
page 7-6
Single, transparent mode only.
Outside Interface Configuration, page 7-28 Single, routed mode only.
Outside Interface Configuration - PPPoE,
page 7-27
Interface Configuration, page 7-27 Single, transparent mode only.
Other Interfaces Configuration, page 7-16 All modes.
Step 13 - Static Routes, page 7-11
Step 14 - DHCP Server, page 7-11
Step 15 - Address Translation (NAT/PAT),
page 7-12
Single, routed mode only.
Step 16 - Administrative Access, page 7-13 All modes.
Step 18 - Startup Wizard Summary, page 7-16