73-11
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 73 Configuring SNMP
Monitoring SNMP
• SNMP Monitoring, page 73-11
SNMP Syslog Messaging
SNMP generates detailed syslog messages numbered 212nnn. Syslog messages indicate the status of
SNMP requests, SNMP traps, SNMP channels, and SNMP responses from the adaptive security
appliance to a specified host on a specified interface.
For detailed information about syslog messages, see Cisco ASA 5500 Series System Log Messages.
SNMP Monitoring
To monitor SNMP, perform the following steps:
Path Purpose
Tools > Command Line Interface
Type show running-config snmp-server,
then click Send.
Displays all SNMP server configuration information.
Tools > Command Line Interface
Type show running-config snmp-server
group, then click Send.
Displays SNMP group configuration settings.
Tools > Command Line Interface
Type show running-config snmp-server
host, then click Send.
Displays configuration settings used by SNMP to control messages and
notifications sent to remote hosts.
Tools > Command Line Interface
Type show running-config snmp-server
user, then click Send.
Displays SNMP user-based configuration settings.
Tools > Command Line Interface
Type show snmp-server engineid, then
click Send.
Displays the ID of the SNMP engine configured.
Tools > Command Line Interface
Type show snmp-server group, then click
Send.
Displays the names of configured SNMP groups.
Note If the community string has already been configured, two extra groups
appear by default in the output. This behavior is normal.
Tools > Command Line Interface
Type show snmp-server statistics, then
click Send.
Displays the configured characteristics of the SNMP server.
Tools > Command Line Interface
Type show snmp-server user, then click
Send.
Displays the configured characteristics of users.
To Next Page
Loading...
Need help?
General
