73-12
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 73 Configuring SNMP
Where to Go Next
Where to Go Next
To configure the syslog server, see Chapter 71, “Configuring Logging.”
Additional References
For additional information related to implementing SNMP, see the following sections:
• RFCs for SNMP Version 3, page 73-12
• MIBs, page 73-12
• Application Services and Third-Party Tools, page 73-14
RFCs for SNMP Version 3
MIBs
For a list of supported MIBs and traps for the adaptive security appliance by release, see the following
URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
To obtain a list of the supported SNMP MIBs for a specific adaptive security appliance, choose Too ls >
Command Line Interface, type the following command, then click Send:
hostname(config)# show snmp-server oidlist
Note Although the oidlist keyword does not appear in the options list for the show snmp-server command
help, it is available.
The following is sample output from the show snmp-server oidlist command:
[0] 1.3.6.1.2.1.1.1. sysDescr
[1] 1.3.6.1.2.1.1.2. sysObjectID
[2] 1.3.6.1.2.1.1.3. sysUpTime
[3] 1.3.6.1.2.1.1.4. sysContact
[4] 1.3.6.1.2.1.1.5. sysName
[5] 1.3.6.1.2.1.1.6. sysLocation
[6] 1.3.6.1.2.1.1.7. sysServices
[7] 1.3.6.1.2.1.2.1. ifNumber
RFC Title
3410 Introduction and Applicability Statements for Internet Standard Management Framework
3411 An Architecture for Describing SNMP Management Frameworks
3412 Message Processing and Dispatching for the Simple Network Management Protocol (SNMP)
3413 Simple Network Management Protocol (SNMP) Applications
3414 User-based Security Model (USM) for Version 3 of the Simple Network Management Protocol (SNMP)
3826 The Advanced Encryption Standard (AES) Cipher Algorithm in the SNMP User-based Security Model
To Next Page
Loading...
Need help?
General
