70-5
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 70 Monitoring VPN
VPN Statistics
–
Bytes Tx/Bytes Rx—Shows the total number of bytes transmitted to/received from the remote
peer or client by the adaptive security appliance.
• Clientless SSL VPN—Indicates that the values in this table relate to Clientless SSL VPN traffic.
–
Username/IP Address—Shows the username or login name for the session and the IP address of
the client.
–
Group Policy Connection Profile—Displays the connection profile of the tunnel group policy.
–
Protocol/Encryption—Shows the protocol and the data encryption algorithm this session is using,
if any.
–
Login Time/Duration—Shows the date and time (MMM DD HH:MM:SS) that the session
logged in. and the length of the session. Time is displayed in 24-hour notation.
–
Bytes Tx/Bytes Rx—Shows the total number of bytes transmitted to/received from the remote
peer or client by the adaptive security appliance.
• SSL VPN Client—Indicates that the values in this table relate to traffic for SSL VPN Client sessions.
–
Username/IP Address—Shows the username or login name for the session and the IP address of
the client.
–
Group Policy Connection Profile—Displays the connection profile of the tunnel group policy.
–
Protocol/Encryption—Shows the protocol and the data encryption algorithm this session is using,
if any.
–
Login Time/Duration—Shows the date and time (MMM DD HH:MM:SS) that the session
logged in. and the length of the session. Time is displayed in 24-hour notation.
–
Bytes Tx/Bytes Rx—Shows the total number of bytes transmitted to/received from the remote
peer or client by the adaptive security appliance.
• E-Mail Proxy—Indicates that the values in this table relate to traffic for Clientless SSL VPN
sessions.
–
Username/IP Address—Shows the username or login name for the session and the IP address of
the client.
–
Protocol/Encryption—Shows the protocol and the data encryption algorithm this session is using,
if any.
–
Login Time/Duration—Shows the date and time (MMM DD HH:MM:SS) that the session
logged in. and the length of the session. Time is displayed in 24-hour notation.
–
Bytes Tx/Bytes Rx—Shows the total number of bytes transmitted to/received from the remote
peer or client by the adaptive security appliance.
The remainder of this section describes the buttons and fields beside and below the table.
• Details—Displays the details for the selected session. The parameters and values differ, depending
on the type of session.
• Logout—Ends the selected session.
• Ping—Sends an ICMP ping (Packet Internet Groper) packet to test network connectivity.
Specifically, the adaptive security appliance sends an ICMP Echo Request message to a selected
host. If the host is reachable, it returns an Echo Reply message, and the adaptive security appliance
displays a Success message with the name of the tested host, as well as the elapsed time between
when the request was sent and the response received. If the system is unreachable for any reason,
(for example: host down, ICMP not running on host, route not configured, intermediate router down,
or network down or congested), the adaptive security appliance displays an Error screen with the
name of the tested host.
To Next Page
Loading...
Need help?
General
