76-14
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 76 Troubleshooting
Common Problems
Symptom Traffic does not pass between two interfaces on the same security level.
Possible Cause You did not enable the feature that allows traffic to pass between interfaces at the
same security level.
Recommended Action Enable this feature according to the instructions in “Allowing Same Security
Level Communication” section on page 8-31.
Symptom IPSec tunnels do not duplicate during a failover to the standby device.
Possible Cause The switch port that the adaptive security appliance is plugged into is set to 10/100
instead of 1000.
Recommended Action Set the switch port that the adaptive security appliance is plugged into to 1000.
To Next Page
Loading...
Need help?
General
