13-18
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 13 Configuring Objects
Configuring Time Ranges
Add/Edit Recurring Time Range
The Configuration > Global Objects > Time Ranges > Add/Edit Time Range >
Add/Edit Periodic Time Range pane lets you fine time ranges further by letting you configure them on
a daily or weekly basis.
For detailed steps on adding a recurring time range to an access rule, see the “Adding a Time Range to
an Access Rule” section on page 13-16.
Note Creating a time range does not restrict access to the device. This pane defines the time range only.
Add/Edit Recurring Time Range Field Descriptions
• Days of the week
–
Every day—Specifies every day of the week.
–
Weekdays—Specifies Monday through Friday.
–
Weekends—Specifies Saturday and Sunday.
–
On these days of the week—Lets you choose specific days of the week.
–
Daily Start Time—Specifies the hour and the minute that the time range begins.
–
Daily End Time (inclusive) area—Specifies the hour and the minute that the time range ends.
The end time specified is inclusive.
• Weekly Interval
–
From—Lists the day of the week, Monday through Sunday.
–
Through—Lists the day of the week, Monday through Sunday.
–
Hour—Lists the hour, in the range of 00 through 23.
–
Minute—Lists the minute, in the range of 00 through 59.