19-2
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 19 Configuring Static and Default Routes
Licensing Requirements for Static and Default Routes
adaptive security appliance might include communications to a syslog server, Websense or N2H2 server,
or AAA server. If you have servers that cannot all be reached through a single default route, then you
must configure static routes. Additionally, the adaptive security appliance supports up to three equal cost
routes on the same interface for load balancing.
Licensing Requirements for Static and Default Routes
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
IPv6 Guidelines
Supports IPv6.
Additional Guidelines
IPv6 static routes are not supported in transparent mode in ASDM.
Configuring Static and Default Routes
This section explains how to configure a static, and a static default route and includes the following
topics:
• Configuring a Static Route, page 19-3
• Configuring a Default Static Route, page 19-7
• Configuring IPv6 Default and Static Routes, page 19-8
Model License Requirement
All models Base License.
To Next Page
Loading...
Need help?
General
