20-7
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 20 Defining Route Maps
Configuration Example for Route Maps
Configuration Example for Route Maps
The following example shows how to redistribute routes with a hop count equal to 1 into OSPF.
Step 1 In ASDM, choose Configuration > Device Setup > Routing > Route Maps.
Step 2 Click Add.
Step 3 Enter 1-to-2 in the Route Map Name field.
Step 4 Enter the routing sequence number in the Sequence Number field.
Step 5 Click the Permit radio button
By default this tab is on top.
Step 6 Click the Match Clause tab.
Step 7 Check the Match Metric of Route check box and type a value of 1 for the metric value.
Step 8 Click the Set Clause tab.
Step 9 Check the Set Metric Value check box, and type a value of 5 for the metric value.
Step 10 Check the Set Metric-Type check box, and choose Type-1.
Feature History for Route Maps
Table 20-1 lists each feature change and the platform release in which it was implemented. ASDM is
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 20-1 Feature History for Static and Default Routes
Feature Name
Platform
Releases Feature Information
Route mapping 7.0(1) The route-map command allows you to define a route map
entry.
The Configuration > Device Setup > Routing > Route
Maps screen was introduced.
Enhanced support for static and dynamic route
maps.
8.0(2) Enhanced support for dynamic and static route maps was
added.
To Next Page
Loading...
Need help?
General
