28-15
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 28 Configuring Twice NAT
Configuring Twice NAT
Step 9 Click OK.
Configuring Identity NAT
This section describes how to configure an identity NAT rule using twice NAT. You configure identity
NAT using a static NAT rule where you map an address to itself. For more information about identity
NAT, see the “Identity NAT” section on page 26-11.
Detailed Steps
To configure identity NAT, perform the following steps:
Step 1 Choose Configuration > Firewall > NAT Rules, and then click Add.
If you want to add this rule to section 3 after the network object rules, then click the down arrow next to
Add, and choose Add NAT Rule After Network Object NAT Rules.
Figure 28-23 Adding a NAT Rule
The Add NAT Rule dialog box appears.
To Next Page
Loading...
Need help?
General
