31-13
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 31 Configuring AAA Servers and the Local Database
Configuring AAA Server Groups
SDI Server Fields
The following table describes the unique fields for configuring SDI servers, for use with the “Adding a
Server to a Group” section on page 31-10.
Windows NT Domain Server Fields
The following table describes the unique fields for configuring Windows NT Domain servers, for use
with the “Adding a Server to a Group” section on page 31-10.
Kerberos Server Fields
The following table describes the unique fields for configuring Kerberos servers, for use with the
“Adding a Server to a Group” section on page 31-10.
Field Description
Server Port The TCP port number by which this server is accessed.
Retry Interval The duration of time, 1 to 10 seconds, that the adaptive security
appliance waits between attempts to contact the server.
Field Description
Server Port Port number 139, or the TCP port number used by the adaptive security
appliance to communicate with the Windows NT server.
Domain Controller The host name (no more than 15 characters) of the NT Primary Domain
Controller for this server (for example, PDC01). You must enter a name,
and it must be the correct host name for the server whose IP address you
added in the field, Authentication Server Address. If the name is
incorrect, authentication fails.
Field Description
Server Port Server port number 88, or the UDP port number over which the adaptive
security appliance communicates with the Kerberos server.