38-21
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 38 Configuring Inspection for Voice and Video Protocols
RTSP Inspection
• You can configure NAT for Apple QuickTime 4 or RealPlayer. Cisco IP/TV only works with NAT
if the Viewer and Content Manager are on the outside network and the server is on the inside
network.
Select RTSP Map
The Select RTSP Map dialog box lets you select or create a new RTSP map. An RTSP map lets you
change the configuration values used for RTSP application inspection. The Select RTSP Map table
provides a list of previously configured maps that you can select for application inspection.
Fields
• Use the default RTSP inspection map—Specifies to use the default RTSP inspection map.
• Select a RTSP inspect map for fine control over inspection—Lets you select a defined application
inspection map or add a new one.
• Add—Opens the Add Policy Map dialog box for the inspection.
Modes
The following table shows the modes in which this feature is available:
RTSP Inspect Map
The RTSP pane lets you view previously configured RTSP application inspection maps. An RTSP map
lets you change the default configuration values used for RTSP application inspection. You can use an
RTSP map to protect RTSP traffic.
Fields
• RTSP Inspect Maps—Table that lists the defined RTSP inspect maps.
• Add—Configures a new RTSP inspect map.
• Edit—Edits the selected RTSP entry in the RTSP Inspect Maps table.
• Delete—Deletes the inspect map selected in the RTSP Inspect Maps table.
Modes
The following table shows the modes in which this feature is available:
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
••••—
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
••••—
To Next Page
Loading...
Need help?
General
