EasyManua.ls Logo

Cisco 840 - Product Safety and Security; Safety and Performance Information

Cisco 840
154 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco accessory part numbers, on page 127
Charger care
Although you don't handle the chargers as much as the phones, they can get dirty, so it's important to periodically
clean them.
The plastic in the charger is different from the plastic in the phone, so it doesn't withstand rigorous disinfection.
Caution
Follow the same steps to clean the charger as you do for the phones, but pay special attention to the following:
Remove the phone and battery from the charger. Unplug the charger.
Never immerse the charger in liquid.
Don't spray any solution directly onto the charger. Dampen a cloth and wipe instead. Do not allow liquid
to pool on or in the plastic.
Don't use a bleach solution on battery contacts.
Don't to exert undue pressure on electrical contacts inside the charger compartment. Do not bend the
contacts.
For light to heavy soil—Wipe the charger surface with a water-dampened cloth or paper towel to remove
most films or residue. If the soiling is too stubborn for plain water, use a mild detergent solution, Lysol
®
,
isopropyl alcohol, or diluted bleach (10 percent or less).
Wipe battery contacts with a cotton swab dampened with alcohol to remove any lint.
Never use the following products to clean your charger:
Don't use furniture polishes, waxes, or plasticizer-based cleaners such as ArmorAll
®
.
Don't use lanolin, aloe, glycerin, or other skin care products.
Don't use hand sanitizers to clean chargers or handle the charger when your hands are wet with
sanitizer solution.
Don't apply any solvent such as acetone, mineral spirits, and so on.
Allow the charger to air dry. You may wipe the charger with a soft dry cloth to hasten dry time. Be sure
that electrical contacts are completely dry and lint-free. When fully dry, you may plug in the charger and
reinsert the battery and phone.
Scanner handle for the Cisco Wireless Phone 840S
There is a scanner handle available for the Cisco Wireless Phone 840S. Use the scanner handle to easily scan
multiple barcodes.
Cisco Wireless Phone 840 and 860 User Guide
125
Accessories
Charger care

Table of Contents

Related product manuals