If set up on your Cisco Wireless Phone 860 or 860S, you can use the fingerprint button to unlock the phone.
However, on power-up you must use a PIN if your phone has a password.
The Cisco Wireless Phone 840 and 840S don't have a fingerprint scanner button.
Note
Procedure
Step 1 If the phone is in sleep mode, briefly press the Power button.
Step 2 If necessary, swipe up on the Lock screen.
Step 3 If necessary, enter your PIN or password and tap Enter .
Related Topics
Hardware and buttons, on page 15
Make an emergency call from a locked screen, on page 54
Lock your phone
It’s best practice to turn off your screen whenever you’re not using your phone. Turning off the screen:
• Locks the phone, keeping it secure.
• Prevents accidentally activating a button when you store the phone in a pocket or other place.
• Helps extend the battery life.
Procedure
Briefly press the Power button.
Related Topics
Hardware and buttons, on page 15
Turn off your phone
Power off the phone when you don't need it.
Don’t remove the battery to power off the phone.
To replace the battery, power off the phone and then remove the battery, or for Cisco Wireless Phone 860,
use the hot swap technique.
Note
Cisco Wireless Phone 840 and 860 User Guide
14
Your phone
Lock your phone
To Next Page
Loading...
Need help?
General
