Procedure
Step 1 To disengage the battery clip, gently use a fingernail to depress the clip towards the top of the phone.
Don’t pull up on or twist the clip. Don't use a tool, such as letter opener or screwdriver, to pry
the clip open. An incorrect prying action with a tool can break the battery clip.
Caution
Step 2 Use your fingernail to lift the battery gently about an eighth of an inch (a few millimeters) out of the battery
compartment.
Step 3 Release the battery clip and grab the battery with your fingers.
Step 4 Use the battery tabs and battery compartment slots as a pivot point to raise the battery edge out the battery
compartment.
Don’t slide the battery across the battery compartment because this action may damage the
contacts.
Warning
Step 5 Gently withdraw the battery tabs from the battery compartment slots and lift the battery out of the battery
compartment.
Make sure that no part of the battery drags across the battery contacts in the phone.
Warning
Hot swap the battery for Cisco Wireless Phone 860 and 860S
The Cisco Wireless Phone 860 and 860S have a hot swap feature that allows you to continue to use your
phone while you change a low battery. During a hot swap, the internal phone battery provides minimum power
to allow the phone to remain on.
You can perform a battery hot swap under most normal operations, such as during a voice call or other activity
on an active phone screen. Active use of the phone or anything that increases the power draw during a hot
swap may, in rare situations, cause the phone to power off.
Cisco Wireless Phone 840 and 860 User Guide
42
Phone setup
Hot swap the battery for Cisco Wireless Phone 860 and 860S
To Next Page
Loading...
Need help?
General
