Cisco 840 - Configure a TFTP Server

Step 11 Tap Save.
Configure a TFTP server
You must configure a TFTP server if your network doesn't provide DHCP option 150 or 66 for the Cisco
Unified Communications Manager that you want to register to.
Configure the DHCP pool with option 150 or 66 if you want to use the automatic configuration method.
Note
Before you begin
You need the following information:
• Local Phone Unlock Password, if the default password was updated
• IP address of the TFTP server
Procedure
Step 1 Access the Cisco Phone app.
Step 2 Choose one of the following based on your phone's software version:
• For release 1.2(0), tap the Overflow menu.
• For release 1.3(0) or later, tap the Drawer menu.
Step 3 Choose one of the following based on your phone's software version:
• For release 1.2(0), select Settings > Phone information > Security.
• For release 1.3(0) or later, select User settings > Phone information > Security.
Step 4 Enter the Local Phone Unlock Password.
The default password is **#.
Step 5 To enable alternate TFTP servers, swipe the Alternate TFTP slider to the right .
Step 6 Enter the TFTP server addresses and tap OK.
Step 7 Tap the back arrow in the upper left corner twice to save your changes and exit the menu.
Cisco Wireless Phone 840 and 860 User Guide
49
Phone setup
Configure a TFTP server