Step 4 Insert the two plastic battery tabs directly into the two battery compartment slots.
Step 5 Use the tab and slot contact point as a pivot to lower the battery into the compartment.
Step 6 Use your finger to press down until you feel and hear the battery clip snap into place.
Related Topics
Phone battery charging, on page 44
Remove the battery
Battery removal follows a reversed but similar procedure to battery insertion.
The steps to remove the battery are the same for both the Cisco Wireless Phone 860 and Cisco Wireless Phone
840. However, the battery contacts are in different locations on these models. The illustrations in the following
steps are of the Cisco Wireless Phone 860.
Cisco Wireless Phone 840 and 860 User Guide
41
Phone setup
Remove the battery
To Next Page
Loading...
Need help?
General
