1. If you connect your headset to the phone with the Y-cable (RJ-9 connector and AUX connector) , make
sure that you enable Electronic HookSwitch Control in the Audio Volume area from Voice > User tab
on the phone administration web page.
2. When you use the Electronic Hookswitch (EHS):
• The EHS connects to the Cisco IP Phone 8811, 8841, and 8845 with the auxiliary port.
• The EHS connects to the Cisco IP Phone 8851, 8861, and 8865 with the auxiliary port, the USB port,
or with Bluetooth.
Note
View the Accessories Associated with Your Phone
You can use the headset jack, Bluetooth, or the USB port to connect external hardware to your phone. The
accessory list, by default, contains an analog headset that can be set up to enable wideband
Procedure
Step 1 Press Applications .
Step 2 Select one of the following options:
• Status > Accessories
• Bluetooth > Devices
Step 3 (Optional) Select an accessory and press Details.
Headsets
Check with the headset manufacturer to confirm whether you can use it with your Cisco phone.
If you plug a headset into the phone during an active call, the audio path automatically changes to the headset.
Important Headset Safety Information
High Sound Pressure—Avoid listening to high volume levels for long periods to prevent
possible hearing damage.
When you plug in your headset, lower the volume of the headset speaker before you put the headset on. If
you remember to lower the volume before you take the headset off, the volume will start lower when you
plug in your headset again.
Be aware of your surroundings. When you use your headset, it may block out important external sounds,
particularly in emergencies or in noisy environments. Don’t use the headset while driving. Don’t leave your
Cisco IP Phone 8800 Series Multiplatform Phones User Guide
163
Accessories
View the Accessories Associated with Your Phone
To Next Page
Loading...
Need help?
General
