Step 5 (Optional) If you turn off WPAD in the previous step, you need to further enter a valid Proxy
Auto-Configuration (PAC) URL in PAC URL. For example:
http://proxy.department.branch.example.com/pac
If you don't have the PAC URL, contact your administrator.
Step 6 Press Set to apply the settings.
Set Up a Proxy Server with the Manual Proxy Mode
You can choose the manual proxy mode to set up an HTTP proxy server on the phone.
Before you begin
Your administrator provides you the server address and port of the proxy server.
Procedure
Step 1 Press Applications .
Step 2 Select Network configuration > HTTP proxy settings > Proxy mode.
Step 3 Press the Select button of the navigation cluster to choose Manual.
Step 4 Enter a valid hostname or IP address of a proxy server in Proxy host.
Do not provide the scheme (http:// or https://) for the proxy host.
Note
Step 5 Enter a valid server port of the specified proxy server in Proxy port.
Step 6 (Optional) If your proxy server requires authentication, highlight Proxy authentication and then select On.
Step 7 (Optional) Enter your username and password to access the proxy server.
If you don't have the username and password, contact your administrator.
Step 8 Press Set to apply the settings.
Set Up a Proxy Server from the Phone Web Page
You can choose the auto or manual proxy mode to set up an HTTP proxy server from the phone web page.
Procedure
Step 1 On the phone web page, select Voice > System.
Step 2 Under the section HTTP Proxy Settings, set the parameters described in the following table:
Cisco IP Phone 8800 Series Multiplatform Phones User Guide
123
Settings
Set Up a Proxy Server with the Manual Proxy Mode
To Next Page
Loading...
Need help?
General
