3-9
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 3 Managing ACE Software Licenses
Removing a License
Removing a License
To remove an installed license, use the license uninstall command in Exec mode
from the Admin context. The syntax for this command is:
license uninstall license_f
ilename
The li
cense_filename argument specifies the filename of the license file that you
want to remove. Enter the license filename as an unquoted text string with no
spaces.
Note When you enter the clear startup-config or the write erase command, the ACE
does not remove license files from the startup-configuration file. You must use the
license uninstall command to remove license files from the ACE.
The following sections provides information about how to remove licences:
• Removing an Appliance Performance Throughput License
• Removing an SSL TPS License
• Removing a Virtualization Context License
• Removing an HTTP Compression Performance License
• Removing the Application Acceleration Software Feature Pack License
Caution When you remove a demo or permanent virtual context license, the ACE removes
all user contexts from the Admin running configuration. By removing the user
contexts, their running and startup configurations are also removed from the ACE.
Before removing any virtual context license, save the Admin running
configuration and the user context running configurations to a remote server. For
more information, see the “Removing a Virtualization Context License” section.
To Next Page
Loading...
Need help?
General
