Cisco ACE-4710-K9

Chapter 5 Managing the ACE Software
Using the File System on the ACE
5-26
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Saving show Command Output to a File
You can force all show screen output to be directed to a file by appending >
filename to any command. For example, you can enter show interface > filename
at the Exec mode CLI prompt to redirect the interface configuration command
output to a file created at the same directory level.
The syntax for redirecting sho
w command output is as follows:
show ke
yword [| {begin pattern | count | end | exclude pattern | include
pattern | last | more}] [> {fi
lename | {disk0:| volatile}:[path/][filename]
| {ftp://server/path[/filename] |
sftp://[username@]server/path[/filename] |
tftp://server[:port]/path[/filename]}
The arguments, keywords, and options include:
• |—(Optional) Enables an output modifier that filters the command output.
• begin pattern—Begins with the line that matches the pattern that you specify.
• count—Counts the number of lines in the output.
• end pattern—Ends with the line that matches the pattern that you specify.
• exclude pattern—Excludes the lines that match the pattern that you specify.
• include pattern—Includes the lines that match the pattern that you specify.
• last—Displays the last few lines of the output.
• more—Displays one window page at a time.
• >—(Optional) Enables an output modifier that redirects the command output
to a file.
• filename—Name of the file that the ACE saves the output to on the volatile:
file system.
• disk0:—Specifies that the destination is the disk0: file system on the ACE
Flash memory.
• volatile:—Specifies that the destination is the volatile: file system on the
ACE.
• [path/][filename]—(Optional) Path and filename to the disk0: or volatile: file
system.