Chapter A Upgrading Your ACE Software
Reloading the ACE
A-10
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Verifying the Boot Variable and Configuration Register
To verify the boot variable and configuration register, use the show bootvar
command in the Admin context from the Exec mode. For example, enter:
host1/Admin# show bootvar
BOOT variable = "disk0:/c4710ace-t1k9-mz.A1_7.bin;disk0:/
c4710ace-mz.3.0.0_AB0_0.488.bin"
Configuration register is 0x1
The “0x1” indicates that the configuration register is set to perform an automatic
boot and to apply the startup-configuration file.
Reloading the ACE
To allow the ACE to use the installed software upgrade, reload the ACE appliance.
To reload the ACE, use the reload command in the Admin context from the Exec
mode. The syntax for this command is:
reload
For example, enter:
host1/Admin# reload
This command will reboot the system
Save configurations for all the contexts. Save? [yes/no]: [yes]
To Next Page
Loading...
Need help?
General
