5-3
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 5 Managing the ACE Software
Saving Configuration Files
Saving the Configuration File in Flash Memory
After you create or update the running-configuration file in RAM (volatile
memory), save the contents to the startup-configuration file for the current context
in Flash memory (nonvolatile memory) on the ACE. To copy the contents of the
running-configuration file to the startup-configuration file, use the copy
running-config startup-config command from Exec mode.
The syntax for the command is:
copy runn
ing-config startup-config
For example, to save the running-configuration file to the startup-configuration
f
ile in Flash memory on the ACE, enter:
host1/Admin# copy running-config startup-config
You can also use the write memory command to copy the contents of the
running-configuration file for the current context to the startup-configuration file.
The write memory command is equivalent to the copy running-config
startup-config command.
The syntax for the command is:
write memory [all]
The optional write memory al
l keyword saves configurations for all existing
contexts. This keyword is available only in the Admin context.
If you intend to use the wr
ite memory command to save the contents of the
running-configuration file for the current context to the startup-configuration file,
be sure to also specify this command in the Admin context. You should save
changes to the Admin context startup-configuration file; the Admin context
startup-configuration file contains all configurations that are used to create each
user context.
To Next Page
Loading...
