Chapter 5 Managing the ACE Software
Using the File System on the ACE
5-24
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
The syntax for this command is:
move disk0:[sou
rce_directory/]filename
disk0:[destination_directory/]filename
The keywords and arguments are:
• source_directory—(Optional) Name of the source directory in the disk0: file
system.
• destination_directory—(Optional) Name of the destination directory in the
disk0: file system.
• filename—Name of the file to move in the disk0: file system.
For example, to move the file called SAMPLEFILE to the MYSTORAGE
directory in the disk0: f
ile system, enter:
host1/Admin# move disk0:SAMPLEFILE disk0:MYSTORAGE/SAMPLEFILE
Deleting Files
To delete a file from a specific file system in the ACE, use the delete command in
Exec mode. When you delete a file, the ACE erases the file from the specified file
system.
Note To remove a directory from the ACE file system, use the rmdir command (see the
“Deleting an Existing Directory” section).
The syntax for this command is:
delete {co
re:filename | disk0:[directory/]filename | image:filename |
volatile:filename}
The keywords and arguments are:
• core:filename—Deletes the specified file from the core: file system (see the
“Viewing and Copying Core Dumps” section). The delete cor
es: command is
available only in the Admin context.
• disk0:[directory/]filename— Deletes the specified file from the disk0: file
system (for example, a packet capture buffer file or system message log). You
can optionally provide a path to a file in directory in the disk0: file system.
To Next Page
Loading...
