1-41
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 1 Setting Up the ACE
Restarting the ACE
Displaying the ACE Boot Configuration
To display the current BOOT environment variable and configuration register
setting, use the show bootvar command in Exec mode.
For example, to display the BOOT environment variable settings, enter:
host1/Admin# show bootvar
BOOT variable =
"image:/c
4710ace-mz.3.0.0_AB0_0.488.bin;image:/c4710ace-mz.3.0.0
_AB0_0.453.bin"
Configuration register is 0x1
Restarting the ACE
To reboot the ACE directly from its CLI and reload the configuration, use the reload
command in Exec mode. The reload command reboots the ACE and performs a
full power cycle of both the hardware and software. The reset process can take
several minutes. Any open connections with the ACE are dropped after you enter
the reload command.
Caution Configuration changes that are not written to the Flash partition are lost after a
reload. Before rebooting, enter the copy running-conf startup-config command
in Exec mode to store the current configuration in Flash memory. If you fail to save
your configuration changes, the ACE reverts to its previous settings upon restart.
When you specify re
load, the ACE prompts you for confirmation and performs a
cold restart of the ACE:
host1/Admin# reload
This command will reboot the system
Save configurations for all the contexts. Save? [yes/no]: yes
Generating configuration....
running config of context Admin saved
Perform system reload. [yes/no]: [yes] yes
To Next Page
Loading...
Need help?
General
