Chapter 7 Configuring Redundant ACE Appliances
Displaying Redundancy Information
7-46
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Displaying the IDMAP Table
The IDMAP table contains a list of the local ACE to peer (standby) ACE ID
mappings for each of the seven object types in the ACE. The local ID and the peer
ID for each object type may or may not be the same, but the mappings (local ID
to peer ID) should be the same on both the active ACE and the standby ACE. The
ACE uses these mappings for configuration synchronization and state replication.
To display the IDMAP table, use the show ft idmap command in Exec mode. The
syntax of this command is as follows:
show ft idmap
Table 7-3
lists the IDMAP table object types available in the ACE.
Ta b l e 7-3 ACE Object Types in the IDMAP Table
Object Type Object Name
0 REAL ID
1 RSERVER ID
2 SERVERFARM ID
3 POLICY ID
4 STICKY GROUP ID
5 IF ID
6 CONTEXT ID
For example, enter:
host1/Admin# show ft idmap
Context Name Name of the context associated with the FT group.
Context ID Identifier of the context associated with the FT group.
Table 7-2 Field Descriptions for the show ft group Command Output
(continued)
Field Description
To Next Page
Loading...
