5-15
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 5 Managing the ACE Software
Using the File System on the ACE
Copying Files
This section contains the following topics:
• Copying Files to Another Directory on the ACE
• Copying Licenses
• Copying a Packet Capture Buffer
• Copying Files to a Remote Server
• Copying Files from a Remote Server
• Copying an ACE Software System Image to a Remote Server
Copying Files to Another Directory on the ACE
To copy a file from one directory in the disk0: file system of Flash memory to another
directory in disk0:, use the copy disk0: command.
Note To view the content of the running- and startup-configuration files, use the dir
disk0: command.
The syntax for this command is:
copy disk0:[pa
th/]filename1 {disk0:[path]filename2}
The keywords and arguments are:
• [path/]filename1—Name of the file to copy. Use the dir disk0: command to
view the files available in the disk0: file system. If you do not provide the
optional path, the ACE copies the file from the root directory on the disk0:
file system.
• disk0:[path]filename2—The file destination in the disk0: directory of the
current context. If you do not provide the optional path, the ACE copies the
file to the root directory on the disk0: file system.
For example, to copy the file called SAM
PLEFILE to the MYSTORAGE
directory in the disk0: file system, enter:
host1/Admin# copy disk0:samplefile disk0:MYSTORAGE/SAMPLEFILE
To Next Page
Loading...
