7-23
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 7 Configuring Redundant ACE Appliances
Configuring Redundancy
Placing an FT Group in Service
Note Before you place an FT group in service, be sure that you have associated one
context with the FT group and that you have properly configured the two peers.
To place an FT group in service, use the inser
vice command in FT group
configuration mode. The syntax of this command is:
inservice
For example, to place an FT g
roup in service, enter:
host1/Admin(config-ft-group)# inservice
To take the FT group out of service, enter:
host1/Admin(config-ft-group)# no inservice
Modifying an FT Group
If you need to modify an FT group, perform the following steps in FT group
configuration mode:
1. Remove the FT group from service by using the no inservice command.
2. Make the necessary modifications to the FT group.
3. Place the FT group back in service by using the inservice command.
Note You can modify the priority, peer priority, and preempt command values
without taking the FT group out of service.
To Next Page
Loading...
Need help?
General
