Chapter 6 Viewing ACE Hardware and Software Configuration Information
Displaying System Information
6-14
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Displaying System Information
To display the system information, use the show system command. The syntax of this
command is:
show system {cpuhog | err
or-id {hex_id | list} | internal | kmemtrack |
resources | skbtrack | uptime}
The keywords, arguments, and options are:
• cpuhog—Displays information related to the process watchdog timer that
monitors CPU usage by any currently active processes.
• error-id—Displays description about errors.
• hex_id—The error ID in hexadecimal format. The range is 0x0 to 0xffffffff.
• list—Specifies all error IDs.
• internal—Specifies a series of internal system-level commands for use by
trained Cisco personnel only.
Max memory size Maximum size (in kbytes) to which a process's
resident
set size may grow. This imposes a limit on
the amount of physical memory to be given to a
process.
Open files Maximum number of open files for this process.
Pipe size Pipe buffer size (in bytes).
Stack size Maximum size (in kbytes) of the stack segment for a
proc
ess.
CPU time Maximum amount of CPU time (in seconds) to be
used by each process
Max user processes Maximum number of simultaneous processes for the
user id
entifier.
Virtual memory Maximum amount (in kbytes) of available virtual
memory
available to the process.
Table 6-9 Field Descriptions for the show terminal internal info
Command (continued)
Field Description
To Next Page
Loading...
