Chapter A Upgrading Your ACE Software
Configuring the ACE to Autoboot the Software Image
A-8
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Configuring the ACE to Autoboot the Software Image
After you copy the image on to the ACE, configure it to autoboot the image by
setting the boot variable and the configuration register. The boot variable specifies
the image from which the ACE boots at startup. The configuration variable can be
set to autoboot the image defined by the boot variable.
This section contains the following topics:
• Setting the Boot Variable
• Configuring the Configuration Register to Autoboot the Boot Variable
• Verifying the Boot Variable and Configuration Register
For detailed information on the boot variable and configuration register, see
Chapte
r 1, Setting Up the ACE.
Setting the Boot Variable
To set the boot variable, use the boot system image: command in the Admin
context from the configuration mode. The syntax for this command is:
boot system image:i
mage_name
The i
mage_name argument is the name of the installed image.
You can set up to two images through the boot
system command. If the first image
fails, the ACE tries the second image.
For example, to set the boot variable with the c4710ace-t1k9-mz.A1_7.bin image,
ente
r:
host1/Admin(config)# boot system image:c4710ace-t1k9-mz.A1_7.bin
Use the no boot system image: command to unset the previously configured boot
variable.
To Next Page
Loading...
