Chapter 8 Configuring SNMP
Configuring SNMP Management Traffic Services
8-38
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Configuring SNMP Management Traffic Services
You configure SNMP management traffic to and from the ACE through the use of
class maps, policy maps, and service policies. The following items summarize the
role of each function in configuring remote network management access to the
ACE:
• Class map—Provides the remote network traffic match criteria to permit
SNMP management traffic based on the SNMP management protocol and the
client source IP address.
• Policy map—Enables remote network management access for a traffic
classification that matches the criteria listed the class map.
• Service policy—Activates the policy map and attaches the traffic policy to a
VLAN interface or globally on all VLAN interfaces.
This section provides an overview on crea
ting a class map, policy map, and
service policy for SNMP access. For detailed information on creating class maps,
policy maps, and service policies, see Chapter 4, Configuring Class Maps and
Policy Maps.
SNMP remote access sessions are established
to the ACE per context. For details
on creating contexts and users, see the Cisco 4700 Series Application Control
Engine Appliance Virtualization Configuration Guide.
This section contains the following topics:
• Creating and Configuring a Layer 3 and Layer 4 Class Map
• Creating a Layer 3 and Layer 4 Policy Map
• Applying a Service Policy
To Next Page
Loading...
Need help?
General
