7-45
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 7 Configuring Redundant ACE Appliances
Displaying Redundancy Information
My State (Cont.) • FSM_FT_STATE_STANDBY_HOT—Local standby
context has all the state information it needs to
statefully assume the active state if a switchover
occurs.
My Config Priority Priority configured on the FT gro
up in the local ACE.
My Net Priority Priority of the FT group equal to the configured priority
min
us the priority of the FT tracking failures if any.
My Preempt Preemption value of the FT group in the local ACE.
Possible v
alues are Enabled or Disabled.
Peer State State of the FT group in the remote ACE. For possible state
v
alues, see the “My State” field description.
Peer Config
Priorit
y
Priority configured for the FT group in the remote ACE.
Peer Net Priority Priority of the FT group in the remote ACE computed from
th
e configured priority and the priority of the FT tracking
failures.
Peer Preempt Preemption value of the FT group in the remote ACE.
Possible v
alues are Enabled or Disabled.
Peer ID FT peer identifier.
Last State Change
T
ime
Time and date that the peer last changed from the active to
standby state, or standby to active state.
Running Cfg Sync
Enabled
Configured state of config sync for the running-config.
Possible v
alues are Enabled or Disabled.
Running Cfg Sync
Status
Current status of config sync for the running-config. For
e
xample: Running configuration sync has completed.
Startup Cfg Sync
Enabled
Configured state of config sync for the startup-conf
ig.
Possible states are Enabled or Disabled.
Startup Cfg Sync
Status
Current status of config sync for the startup-config. For
e
xample: Startup configuration sync is disabled.
No. of Contexts Number of contexts associated with the FT group.
Table 7-2 Field Descriptions for the show ft group Command Output
(continued)
Field Description
To Next Page
Loading...
