Chapter 5 Managing the ACE Software
Reformatting Flash Memory
5-42
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
If the ACE fails to extract a system image from the Grub bootloader, it prompts
you to provide the location of an available system image to backup:
Failed to extract system image Information from Grub
backup specific imagefile? (yes/no) [no] yes
Enter Image name: c4710ace-t1k9-mz.A1_7.bin
Saving Image [c4710ace-t1k9-mz.A1_7.bin]
Formatting the cf.....
Unmounting ext3 filesystems...
Unmounting FAT filesystems...
Unmounting done...
Unmounting compact flash filesystems...
format completed successfully
Restoring Image backupimage/scimi-3.bin
kjournald starting. Commit interval 5 seconds
REXT3 FS on hdb2, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
starting graceful shutdown
switch/Admin# Unmounting ext3 filesystems...
Unmounting FAT filesystems...
Unmounting done...
After you reformat the Flash memory, perform the following actions:
• Reinstall the ACE software image by using the copy image: command (see
Appendix A, Upgrading Your ACE Software).
• Reinstall the ACE license by using the license install command (see
Chapter 3, Managing ACE Software Licenses).
• Import the startup and running-configuration files into the associated context
by using the copy command (see the “Loading Configuration Files from a
Remote Server” section).
• Import SSL certificate files and key pair files into the associated context using
by the crypto import command (see the Cisco 4700 Series Application
Control Engine Appliance SSL Configuration Guide).
To Next Page
Loading...
