7-57
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 7 Configuring Redundant ACE Appliances
Displaying Redundancy Information
My State (Cont.) • FSM_FT_STATE_STANDBY_HOT—State that
indicates that the local standby context has all the state
information it needs to statefully assume the active
state if a switchover occurs.
My Config Priority Priority configured on the FT gro
up in the local ACE.
My Net Priority Priority of the FT group equal to the configured priority
min
us the priority of the FT tracking process failures, if
any.
My Preempt Preemption value of the FT group in the local ACE.
Possible v
alues are Enabled or Disabled.
Context Name Name of the context that is associated with the FT group.
Context ID Identifier of the context that is as
sociated with the FT
group.
Track Type Type of object being tracked. Possible values are
TRA
CK_HOST or TRACK_INTERFACE.
State State of the tracking process. Possible values are
TRA
CK_UP or TRACK_DOWN.
Priority Priority of the tracking process.
Transitions Number of times that the active member of the FT group
swit
ched over to the standby member.
Probe Count Number of probes associated with a TR
ACK_HOST
process.
Probes Down Number of failed probes.
Table 7-6 Field Descriptions for the show ft track Command Output
(continued)
Field Description
To Next Page
Loading...
