REVIEW DRAFT - CISCO CONFIDENTIAL
9-19
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 9 Configuring the XML Interface
Configuring HTTP and HTTPS Management Traffic Services
• insert-before name2—(Optional) Places the current class map ahead of an
existing class map or inline match condition specified by the name2 argument
in the policy map configuration. The ACE does not save the sequence
reordering as part of the configuration. Enter an unquoted text string with no
spaces and a maximum of 64 alphanumeric characters.
• class-default—Specifies the class-default class map for the Layer 3 and
Layer 4 traffic policy. This class map is a reserved class map created by the
ACE. You cannot delete or modify this class. All network traffic that fails to
meet the other matching criteria in the named class map belongs to the default
traffic class. If none of the specified classifications match, the ACE then
matches the action specified under the class class-default command. The
class-default class map has an implicit match any statement in it and is used
to match any traffic classification. The class-default class map has an
implicit match any statement that matches all traffic.
For example, to specify an e
xisting class map within the Layer 3 and Layer 4
remote access policy map, enter:
host1/Admin(config-pmap-mgmt)# class XML-HTTPS-ALLOW_CLASS
host1/Admin(config-pmap-mgmt-c)#
To use the insert-before command to define the sequential order of two class
maps in the policy map, enter:
host1/Admin(config-pmap-mgmt)# class XML-HTTPS-ALLOW_CLASS
insert-before L4_REMOTE_ACCESS_CLASS
To specify the class-default class map for the Layer 3 and Layer 4 traffic policy,
enter:
host1/Admin(config-pmap-mgmt)# class class-default
host1/Admin(config-pmap-mgmt-c)#
To remove a class map from a Layer 3 and Layer 4 policy map, enter:
host1/Admin(config-pmap-mgmt)# no class XML-HTTPS-ALLOW_CLASS
To Next Page
Loading...
