REVIEW DRAFT - CISCO CONFIDENTIAL
9-21
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 9 Configuring the XML Interface
Configuring HTTP and HTTPS Management Traffic Services
The syntax of this command is:
service-policy input po
licy_name
The keywords, arguments, and options are:
• input—Specifies that the traffic policy is to be attached to the input direction
of an interface. The traffic policy evaluates all traffic received by that
interface.
• policy_name—Name of a previously defined policy map, configured with a
previously created policy-map command. The name can be a maximum of 40
alphanumeric characters.
For example, to specify an interface V
LAN and apply an XML HTTPS
management policy to the VLAN, enter:
host1/Admin(config)# interface vlan 50
host1/Admin(config-if)# ip addres
s 192.168.10.1 255.255.0.0
host1/Admin(config-if)# service-p
olicy input MGMT_XML-HTTPS_POLICY
For example, to globally apply an XML HTTPS management policy to all of the
VLANs associated with a context, enter:
host1/Admin(config)# service-policy input MGMT_XML-HTTPS_POLICY
To detach the XML HTTPS management policy from an interface, enter:
host1/Admin(config-if)# service-policy input MGMT_XML-HTTPS_POLICY
To detach the XML HTTPS management policy from an interface, enter:
host1/Admin(config-if)# no service-policy input MGMT_XML-HTTPS_POLICY
To globally detach the XML HTTPS management policy from all VLANs
associated with a context, enter:
host1/Admin(config)# no service-policy input MGMT_XML-HTTPS_POLICY
To Next Page
Loading...
