1-27
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 1 Setting Up the ACE
Synchronizing the ACE with an NTP Server
For example, to display the statistic counters related to the memory code, enter:
switch/Admin# show ntp statistics memory
Table 1-6 describes the fields in the show ntp statistics memory command
output.
Ta b l e 1-6 Field Descriptions for show ntp statistics memory Command
Field Description
Time since reset Time in hours since the ACE was last rebooted.
Total peer memory Total peer memory available for the allocation of
memory to
peer structures.
Free peer memory Current available peer memory.
Calls to findpeer The number of calls to findpeer.
Note findpeer is an entry point to the allocation of
memory to peer structures that looks for
matching peer structures in the peer list.
New peer allocations Number of allocations from the free list.
Peer demobilizations Number of structures freed
to the free list.
Hash table counts The count of peers in each hash table.
For example, to display the per-peer statistics counter of a peer, enter:
switch/Admin# show ntp statistics peer 192.168.1.2
Table 1-7 describes the fields in the show ntp statistics peer command output.
Ta b l e 1-7 Field Descriptions for show ntp statistics peer Command
Field Description
Remote Host IP address of the specif
ied peer.
Local Interface IP address of specified local interface.
Time Last Received Time that the last NTP response was received.
Time Until Next Send Length of time until the next send attempt.
Reachability Change The reachability status for the peer.
To Next Page
Loading...
