Index
IN-4
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
cautions xix
CC (command switch) 5-20
CDP 1-3
automatic discovery in switch clusters 5-4
configuring 6-13, 6-14
disabling for routing device 11-2
change notification, CMS 2-32
chassis system error messages B-3
Cisco Access Analog Trunk Gateway 1-13
Cisco CallManager software 1-12, 1-13
Cisco Discovery Protocol
see CDP
Cisco IP Phones
1-12
Cisco SoftPhone software 1-12
CiscoWorks 2000 1-6, 4-5
class maps for QoS
configuring
13-17
described 13-5
displaying 13-25
class of service
See CoS
CLI
1-6
accessing 3-9
saving changes 3-10
client mode, VTP 8-8
Cluster Management Suite 1-6
See CMS
Cluster Membership Protocol
see CMP system error messages
B-3
clusters, switch
accessing
5-13
adding member switches 5-18
automatic discovery 5-4
automatic recovery 5-10
command switch configuration 5-17
compatibility 5-4
creating 5-16
creating a cluster standby group 5-20
described 5-1
clusters, switch (continued)
LRE profile considerations
5-16
management VLAN, changing 8-3
managing through CLI 5-23
managing through SNMP 5-24
planning considerations
automatic discovery
5-4
automatic recovery 5-10
CLI 5-23
described 5-4
host names 5-14
IP addresses 5-13
LRE profiles 5-16
management VLAN 5-15
passwords 5-14
SNMP 5-14, 5-24
switch-specific features 5-16
TACACS+ 5-15
redundancy 5-20
troubleshooting 5-22
verifying 5-22
See also candidate switch, command switch, cluster
standby group, and member switch
cluster standby group
automatic recovery
5-11
considerations 5-12
creating 5-20
defined 5-2
requirements 5-3
virtual IP address 5-11
See also HSRP
cluster tree
described
2-5
icons 2-5
CMP system error messages B-3
CMS
accessing
2-30
access levels 2-31
advantages 1-7
To Next Page
Loading...
