Cisco Catalyst 2950 - Displaying SPAN Status

10-25
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
Chapter 10 Configuring the Switch Ports
Configuring SPAN
The monitoring of traffic received on port 1 is disabled, but traffic sent from this port continues to be
monitored.
Displaying SPAN Status
To display the status of the current SPAN configuration, use the show monitor privileged EXEC
command.
This is an example of output for the show monitor privileged EXEC command for session 1:
Switch# show monitor session 1
Session 2
---------
Source Ports:
RX Only: Gi0/1
TX Only: None
Both: None
Destination Ports:Gi0/2