B-3
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
Appendix B System Messages
Error Message Traceback Reports
Error Message Traceback Reports
Some messages describe internal errors and contain traceback information. This information is very
important and should be included when you report a problem to your technical support representative.
This is a sample message includes traceback information:
-Process= "Exec", level= 0, pid= 17
-Traceback= 1A82 1AB4 6378 A072 1054 1860
Error Messages and Recovery Procedures
This section lists the switch system messages by facility. Within each facility, the messages are listed by
severity levels 0 to 7: 0 is the highest severity level, and 7 is the lowest severity level. Each message is
followed by an explanation and a recommended action.
Chassis Message
This section contains the Chassis error message.
Error Message CHASSIS-5-BLADE_EXTRACT
Explanation
The message means that the hot-swap switch has been pressed.
Recommended Action Extract the module.
CMP Messages
This section contains the Cluster Membership Protocol (CMP) error messages.
Error Message CMP-5-ADD: The Device is added to the cluster (Cluster Name:[chars],
CMDR IP Address [inet])
Explanation
The message means that the device is added to the cluster: [chars] is the cluster name,
and [inet] is the Internet address of the command switch.
Recommended Action No action is required.
Error Message CMP-5-MEMBER_CONFIG_UPDATE: Received member configuration from member
[dec]
Explanation This message means that the command switch received a member configuration: [dec] is
the member number.
Recommended Action No action is required.
To Next Page
Loading...
