Cisco Catalyst 2950 - Switch Port Analyzer

4-10
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
Chapter 4 General Switch Administration
Default Settings
Quality of Service (QoS)
3
Disabled “Configuring Classification Using Port Trust
States” sectiononpage13-10.
“Configuring a QoS Policy” section on
page 13-13.
“Configuring CoS Maps” section on
page 13-21.
Device > QoS
Diagnostics
Displaying graphs and
statistics
Enabled – Reports
Switch Port Analyzer
(SPAN) port monitoring
Disabled “Configuring SPAN” sectiononpage10-22. Port > Switch Port Analyzer
(SPAN)
Console, buffer, and file
logging
Disabled –
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
–
Remote monitoring
(RMON)
Disabled “SNMP Network Management Platforms”
sectiononpage4-4.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
–
System Messages Appendix B, “System Messages.” Report > System Messages
Security
Password None “Passwords” sectiononpage5-14and
“Changing the Password” section on
page 6-10.
–
Addressing security Disabled “Managing the MAC Address Tables” section
on page 6-15.
Administration > MAC
Addresses
Trap manager 0.0.0.0 “Adding Trap Managers” section on
page 6-12.
Administration > SNMP
Community strings public “SNMP Community Strings” section on
page 5-14 and “Entering Community Strings”
sectiononpage6-12.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Administration > SNMP
Port security Disabled “Enabling Port Security” section on
page 10-6.
Port > Port Security
Terminal Access Controller
Access Control System Plus
(TACACS+)
Disabled “Configuring TACACS+” section on
page 6-20.
–
Protected port Disabled “Configuring Protected Ports” section on
page 10-5.
Port > Protected Port
Table 4-2 Default Settings and Where To Change Them (continued)
Feature
Default
Setting Concepts and CLI Procedures CMS Option