Cisco Catalyst 2950 - Page 91

4-9
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
Chapter 4 General Switch Administration
Default Settings
Performance
Configuring a port None Chapter 10, “Configuring the Switch Ports.” Port > Port Settings
Duplex mode Auto “Changing the Port Speed and Duplex Mode”
sectiononpage10-1.
Port > Port Settings
Speed on 10/100 ports Auto “Changing the Port Speed and Duplex Mode”
sectiononpage10-1.
Port > Port Settings
Gigabit Ethernet Flow “Configuring Flooding Controls” section on
page 10-4.
Port > Port Settings
Flooding Control
Storm control Disabled “Configuring Flooding Controls” section on
page 10-4.
Port > Flooding Control
Flooding unknown unicast
and multicast packets
Enabled “Configuring Protected Ports” section on
page 10-5.
Port > Flooding Control
IGMP Snooping Enabled “Understanding and Configuring IGMP
Snooping” section on page 11-1.
“Enabling or Disabling IGMP Snooping”
sectiononpage11-2.
“Immediate-Leave Processing” section on
page 11-3.
“CLI: Configuring a Multicast Router Port”
sectiononpage11-7.
Device > IGMP Snooping
Multicast VLAN
Registration (MVR)
Disabled “Understanding Multicast VLAN
Registration” sectiononpage11-7.
–
Network Redundancy
Hot Standby Router
Protocol
Disabled “Creating a Cluster Standby Group” section
on page 5-20.
Cluster > Standby Command
Switches
Spanning Tree Protocol Enabled “Configuring Basic STP Features” section on
page 9-20.
“Configuring Advanced STP Features”
sectiononpage9-30.
Device > Spanning Tree
Protocol (STP)
Unidirectional link
detection
Disabled “Configuring UniDirectional Link Detection”
sectiononpage10-18.
–
Port grouping None
assigned
“Understanding the EtherChannel” section on
page 10-8.
Port > EtherChannels
QoS and Security
Access Control Lists
(ACLs)
3
None
assigned
“Guidelines for Configuring ACLs on the
Catalyst 2950 Switches” sectiononpage12-5.
“Creating Standard and Extended IP ACLs”
sectiononpage12-7.
Device > ACLs
Table 4-2 Default Settings and Where To Change Them (continued)
Feature
Default
Setting Concepts and CLI Procedures CMS Option