Cisco Catalyst 2950 - Page 90

4-8
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
Chapter 4 General Switch Administration
Default Settings
Domain name None “Configuring the Domain Name and the DNS”
sectiononpage6-5.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Administration > IP Addresses
Cisco Discovery Protocol
(CDP)
Enabled “Configuring CDP” sectiononpage6-13.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Cluster > Hop Count
Address Resolution
Protocol (ARP)
Enabled “Managing the ARP Table” section on
page 6-14.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Administration > ARP
CoS and WRR Disabled “CoS and WRR” sectiononpage13-8. Device > QoS
System Time Management None “Setting the System Date and Time” section
on page 6-11.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Administration > System Time
Mac Address Notification Disabled “MAC Address Notification” section on
page 6-17.
–
Static address assignment None
assigned
“Adding and Removing Static Address
Entries” section on page 6-18.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Administration > MAC
Addresses
Dynamic address
management
Enabled “Managing the MAC Address Tables” section
on page 6-15.
Documentationsetfor Cisco IOS Release 12.1
on Cisco.com.
Administration > MAC
Addresses
VLAN membership – “Assigning VLAN Port Membership Modes”
sectiononpage8-4.
VLAN > VLAN
VMPS Configuration – “How the VMPS Works” section on
page 8-28.
VLAN > VMPS
VTP Management VTP server
mode
“Configuring VTP” sectiononpage8-12. VLAN > VLAN
Table 4-2 Default Settings and Where To Change Them (continued)
Feature
Default
Setting Concepts and CLI Procedures CMS Option