Index
IN-18
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-03
SPAN (continued)
sessions (continued)
removing source (monitored) ports
10-24
specifying monitored ports 10-23
source ports 10-20
transmitted traffic 10-19
Spanning Tree Protocol
See STP
speed, setting
10-1, 10-2
Stack Membership Discovery Protocol 9-13
Standby Command Configuration window 5-21
standby command switch
configuring
5-20
considerations 5-12
defined 5-2
priority 5-10
requirements 5-3
virtual IP address 5-11
See also cluster standby group and HSRP
standby group, cluster
See cluster standby group and HSRP
static access mode
2-9
static-access ports
assigningtoVLAN
8-7, 8-19
described 8-7
VLAN membership combinations 8-6
static addresses
adding
6-18
configuring for EtherChannel port groups 6-19
described 6-15, 6-18
see also static address
static address forwarding
6-18
statistics
QoS ingress and egress
13-25
statistics, VTP 8-15
statistics group, in RMON 4-4
STP
accelerating root port selection
9-11
BackboneFast, described 9-17
BPDU guard, described 9-10
BPDU message exchange 9-3
configuring
BackboneFast
9-34
BPDU guard 9-31
cross-stack UplinkFast 9-33
disable 9-21
forward-delay time 9-27
hello time 9-27
in cascaded cluster 9-28
maximum aging time 9-28
path cost 9-25
Port Fast 9-30
port priority 9-24
root guard 9-34
root switch 9-21
secondary root switch 9-23
switch priority 9-26
UplinkFast with redundant links 9-32
cross-stack UplinkFast, described 9-12
default configuration 9-20
designated switch, defined 9-4
detecting indirect link failures 9-17
displaying status 9-29
interface state, blocking to forwarding 9-10
interface states
blocking
9-6
disabled 9-7
forwarding 9-6, 9-7
learning 9-7
listening 9-7
overview 9-5
limitations with 802.1Q trunks 9-8
To Next Page
Loading...
