141
Configuring SDM Templates
Configuration Examples for Configuring SDM Templates
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K
number of IPv6 policy based routing aces: 0
number of IPv6 qos aces: 0
number of IPv6 security aces: 0
Configuring Lanbase Templates: Example
This is an example of output from the show sdm prefer command on a Lanbase image:
Switch# show sdm prefer
The current template is "IPv4 default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 16K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 5.25K
number of directly-connected IPv4 hosts: 4K
number of indirect IPv4 routes: 1.25K
number of IPv6 multicast groups: 1K
number of IPv6 unicast routes: 5.25K
number of directly-connected IPv6 addresses: 4K
number of indirect IPv6 unicast routes: 1.25K
number of IPv4 policy based routing aces: 0.25K
number of IPv4/MAC qos aces: 1K
number of IPv4/MAC security aces: 1K
number of IPv6 policy based routing aces: 0.25K
number of IPv6 qos aces: 0.25K
number of IPv6 security aces: 0.25K
To Next Page
Loading...
Need help?
General