Cisco IE-5000 User Manual

313
Configuring Voice VLAN
Configuration Examples for Configuring Voice VLAN
Configuration Examples for Configuring Voice VLAN
Configuring the Cisco IP Phone Priority of Incoming Data Frames: Example
This example shows how to configure a port connected to a Cisco IP phone to not change the priority of frames received
from the PC or the attached device:
Switch(config)# interface GigabitEthernet1/17
Switch(config-if)# switchport priority extend trust
Switch(config-if)# end
Additional References for Configuring Voice VLAN
The following sections provide references related to switch administration:

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes