Cisco IE-5000 User Manual

351
Configuring MSTP
Configuration Examples for Configuring MSTP
Configuration Examples for Configuring MSTP
Configuring the MST Region: Example
This example shows how to enter MST configuration mode, map VLANs 10 to 20 to MST instance 1, name the region
region1, set the configuration revision to 1, display the pending configuration, apply the changes, and return to global
configuration mode:
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# instance 1 vlan 10-20
Switch(config-mst)# name region1
Switch(config-mst)# revision 1
Switch(config-mst)# show pending
Pending MST configuration
Name [region1]
Revision 1
Instance Vlans Mapped
-------- ---------------------
0 1-9,21-4096
1 10-20
-------------------------------
Switch(config-mst)# exit
Switch(config)#
Additional References
The following sections provide references related to switch administration:

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes