463
Configuring Port-Based Traffic Control
Additional References
Switch(config-if)# switchport port-security violation restrict
Switch(config-if)# switchport port-security mac-address sticky
Switch(config-if)# switchport port-security mac-address sticky 0000.0000.0002
Switch(config-if)# switchport port-security mac-address 0000.0000.0003
Switch(config-if)# switchport port-security mac-address sticky 0000.0000.0001 vlan voice
Switch(config-if)# switchport port-security mac-address 0000.0000.0004 vlan voice
Switch(config-if)# switchport port-security maximum 10 vlan access
Switch(config-if)# switchport port-security maximum 10 vlan voice
Configuring Port Security Aging: Examples
This example shows how to set the aging time as 2 hours for the secure addresses on a port:
Switch(config)# interface GigabitEthernet1/17
Switch(config-if)# switchport port-security aging time 120
This example shows how to set the aging time as 2 minutes for the inactivity aging type with aging enabled for the
configured secure addresses on the interface:
Switch(config-if)# switchport port-security aging time 2
Switch(config-if)# switchport port-security aging type inactivity
Switch(config-if)# switchport port-security aging static
You can verify the previous commands by entering the show port-security interface interface-id privileged EXEC
command.
Configuring Protocol Storm Protection: Example
This example shows how to configure protocol storm protection to drop incoming DHCP traffic on DHCP when it exceeds
35 packets per second:
Switch# configure terminal
Switch(config)# psp dhcp pps 35
Additional References
The following sections provide references related to switch administration:
To Next Page
Loading...
Need help?
General
